|
|
(4 intermediate revisions by 3 users not shown) |
Line 1: |
Line 1: |
| ==Problems==
| | #REDIRECT [[Oxygen signal]] |
| *The oxygen signal remains at or close to zero even at high oxygen levels.
| |
| *The signal at air saturation is abnormally low.
| |
| | |
| ==Test and Solutions==
| |
| | |
| '''The oxygen signal is very low at air saturation and less responsive than expected.'''
| |
| :'''Solution 1:''' Check the [[gain]] setting for the affected oxygen channel.
| |
| ::::*The gain setting was too low, and the oxygen signal increases to the expected level after increasing the gain.
| |
| ::::*The gain was correct: Locate the problem using the procedure described in [[Locating a Problem]] and [[Sensor test]].
| |
| | |
| | |
| {{#set: Technical service=O2 sensor|Technical service=O2 signal}}
| |
| | |
| {{Technical service}}
| |
| | |
| __SHOWFACTBOX__
| |